Kangaroo Hillcrest ABX Manual - page 17

Assembl

y

16

If the Upper Caddie Structure or Electronic Front Drive is loose, turn the draw latch metal adjustment ring clockwise 

to tighten. Do not over-tighten the adjustment ring as this may cause the draw latch to break when engaged. If the 

draw latch will not lock in place, loosen the draw latch by turning the metal adjustment ring counter-clockwise. 

(Figure 6)

Note: The metal adjustment ring may be difficult to turn. A standard pair of needle nose pliers can be used  

to make adjustments. To avoid possible breakage, always close draw latches before placing Chassis into your car.

Flex-Adjust Bag Support:

The Flex-Adjust Bag Support on the Upper Caddie Structure (

Figure 7), also referred to as the yoke, is designed to 

fold up for easy transportation and storage. It can be adjusted to grip your golf bag by bending the arms open or 

closed as needed.

The Flex-Adjust Bag Support is attached to the stainless steel tubing at the best position to hold most golf bags 

securely. If you have an unusual bag, or a personal preference for its position, its clamp can be moved up or down 

the tubing to any point you like. The Bag Support is secured with four 5/32” Allen-type machine screws and a 

suitable wrench is provided with your X-Series. Simply loosen the four screws and adjust the clamps accordingly, 

then re-tighten securely.