Kangaroo Hillcrest ABX Manual - Remote Guidance System

Remote Guidance Sy

S

tem

24

Remote Guidance System

Remote Guidance System consists of three components – the Remote Transmitter

 (Figure 12), Remote Receiver 

(Figure 13), and Electronic Front Drive (Figure 14). Remote Guidance System operates on an FM Pulse Code 

Transmittal System that is FCC approved, and requires no operator’s license. Remote Guidance System is relatively 

low power (milliamps) and is subject to little outside interference.

Remote Transmitter and Remote Receiver devices comply with Part 15 of FCC rules. Operation of these devices is 

subject to the following two conditions: (1) The devices may not cause harmful interference, and (2) The devices 

must accept any interference received, including interference that may cause unintended operation.

The antenna is permanently mounted inside the Remote Receiver to make it more water resistant. You should not 

attempt to open the Remote Receiver - doing so will break the seal and void the warranty.

Activating Remote Guidance System

See 

Power Controls & Operations on page 18.