Karcher HDS 698 C ECO Operating Instructions Manual - Operation
– 5
Danger
Danger of injury by electric shock.
–
Unsuitable extension cables can be
hazardous. Only use extension cables
outdoors which have been approved for
this purpose and labelled with a suffi-
cient cable cross section:
–
Always unwind extension lines com-
pletely.
–
The plug and coupling of the extension
cable used must be watertight.
Main Plug Assembly:
–
Have Kärcher customer service or an-
other authorized electrical professional
install the main plug.
Set the appliance switch to "0".
Plug in the main plug.
Caution
Check direction of rotation of the engine at
every socket change.
–
With correct direction of rotation a
strong airflow can be felt out of the ex-
haust opening of the burner.
–
For incorrect direction of rotation refer
to "Help with malfunctions - burner is
not igniting".
Danger
Risk of explosion!
Do not spray flammable liquids.
Danger
Risk of injury! Never use the appliance
without the spray lance attached. Check
and ensure proper fitting of the spray lance
prior to each use. The screw connection of
the spray lance must be fingertight.
Caution
Never operate device with empty fuel tank
The fuel pump will otherwise be destroyed.
몇
Warning
Long hours of using the appliance can
cause circulation problems in the hands on
account of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sev-
eral factors:
–
Proneness to blood circulation deficien-
cies (cold, numb fingers).
–
Low ambient temperature. Wear warm
gloves to protect hands.
–
A firm grip impedes blood circulation.
–
Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
Danger
Switch the appliance off prior to replacing
nozzel and activate hand spray gun until
device is pressureless.
Set the appliance switch to "I".
Indicator lamp for operational readiness
lights up.
Note: If the control lamps fuel low, liquid
softener or exhaust temperature limiter
light up, please switch the appliance off im-
mediately and fix the error, see "Help with
malfunctions".
The device starts briefly and turns off, as
soon as the working pressure is reached.
Figure 5
Release the hand spray gun (A).
When activating the hand spray gun the de-
vice switches back on.
Note:If no water comes out of the high
pressure nozzle, vent pump. Refer to "Help
with malfunctions - appliance is not building
up pressure".
Set device switch to desired tempera-
ture.
30 °C to 98 °C
–
Clean with hot water.
100 °C to 150 °C
–
Clean using steam.
Operation
Safety instructions
Replace the nozzle
Turning on the Appliance
Adjust cleaning temperature
23
EN