Karcher NT 20/1 ME Classic Manual - Device Elements
– 2
1 Fastening clip
2 Cartridge filter
3 Float
4 Suction head
5 Suction hose with manifold
6 Cable hook/jack for manifold
7 Hose/cable holder
8 Carrying handle
9 Suction head lock
10 Dirt receptacle
11 Steering roller
12 Chassis
13 Floor nozzle for wet vacuum cleaning
14 Floor nozzle for dry vacuum cleaning
15 Switch between hard surface/carpet
16 Suction support
17 Main switch
18 Suction tube
19 Holder (narrow)
20 Holder (wide)
21 Power cord
22 Nameplate
Caution
For vacuuming, the cartridge filter must al-
ways be installed.
–
To vacuum fine dust, you can also use
an additional paper filter bag.
–
When changing from wet to dry vacuum
cleaning, the wet cartridge filter must be
dried or replaced with a dry cartridge fil-
ter first.
Illustration
Release and remove the suction head.
Insert the paper filter bag.
Insert and lock the suction head.
–
To suck wet dirt, first remove the paper
filter bag.
Plug in the main plug.
Switch on the appliance at the main
switch.
Dry vacuum cleaning: Use floor nozzle
for dry vacuum cleaning.
Set the selection switch of the floor noz-
zle to hard surface or carpet.
Wet vacuum cleaning: Use floor nozzle
for wet vacuum cleaning.
Perform the cleaning operation.
–
The vacuum channel is equipped with a
float.
–
When the dirt water reaches the highest
permissible level in the container, the
suction power is interrupted.
Switch off the appliance at the main
switch.
Release and remove the suction head.
Empty the dirt container.
Switch off the appliance at the main
switch.
Pull out the mains plug.
Empty the dirt container.
Vacuum and wipe the appliance inside
and outside with a damp cloth.
Device elements
Start up
Dry vacuum cleaning
Inserting the paper filter bag
Wet vacuum cleaning
Remove the paper filter bag
Operation
Turning on the Appliance
Cleaning operations
Emptying the dirt container
Turn off the appliance
After each operation
16
EN