Karel DS200 Installation Manual - page 29
DS200 Installation Guide
DS200 Installation Guide
DS200 Installation Guide
DS200 Installation Guide
V003. 25.06.2002
B-28
Connection orders of both signaling and voice transmission wires for cabling E&M lines are
important.
These wires should be connected by being crossed within their own groups.
Those orders are given in the table below for two correspondent exchanges:
RJ45 wire order on Wire order on the
DS200 side
Signal
opposite side
1
E
M
2
SG
SB
3
M
E
4
SB
SG
5
T
R1 (R, if it is 2-wire)
6
R
T1 (T, if it is 2-wire)
7
T1
R
8
R1
T
I.4.E. JUMPER SETTINGS ON THE EX200 (8T0/S0)
MODULE
The ISDN BRI lines of the EX200 (8 T0/S0) module can be configured as either external line or
extension. (The software with the version 1.05 does not support the configuration for
extension.) This setting operation is done trough jumpers that exist within the structure of
each line. The list of those settings are given per line in the table below:
Line Number
Positions of the jumpers for extension settings
1st ISDN BRI line
K4, K5 – pins 1,2 and K6, K7 – pins 1,2
2nd ISDN BRI line
K8, K9 – pins 1,2 and K10, K11– pins 1,2
3rd ISDN BRI line
K12, K13 – pins 1,2 and K14, K15 – pins 1,2
4th ISDN BRI line
K16, K17 – pins 1,2 and K18, K19 – pins 1,2
5th ISDN BRI line
K20, K21 – pins 1,2 and K22, K23 – pins 1,2
6th ISDN BRI line
K24, K25 – pins 1,2 and K26, K27 – pins 1,2
7th ISDN BRI line
K28, K29 – pins 1,2 and K30, K31 – pins 1,2
8th ISDN BRI line
K32, K33 – pins 1,2 and K34, K35 – pins 1,2
Line Number
Positions of the jumpers for line settings
1st ISDN BRI line
K4, K5 – pins 2,3 and K6, K7 – pins 2,3
2nd ISDN BRI line
K8, K9 – pins 2,3 and K10, K11– pins 2,3
3rd ISDN BRI line
K12, K13 – pins 2,3 and K14, K15 – pins 2,3
4th ISDN BRI line
K16, K17 – pins 2,3 and K18, K19 – pins 2,3
5th ISDN BRI line
K20, K21 – pins 2,3 and K22, K23 – pins 2,3
6th ISDN BRI line
K24, K25 – pins 2,3 and K26, K27 – pins 2,3
7th ISDN BRI line
K28, K29 – pins 2,3 and K30, K31 – pins 2,3
8th ISDN BRI line
K32, K33 – pins 2,3 and K34, K35 – pins 2,3