Karel DS200 Installation Manual - page 30
DS200 Installation Guide
DS200 Installation Guide
DS200 Installation Guide
DS200 Installation Guide
V003. 25.06.2002
B-29
I.4.F. JUMPER SETTINGS ON THE EX200 (4E&M/0)
MODULE
Since several different configurations are possible for the E&M module, unlike the others,
some configuration settings must be done on it before it is installed in the system. Those
settings are done through jumpers. A list of jumper settings for different configurations is as
follows:
A) FOR THE SIGNALING CHANNEL CONFIGURATION:
Type 1:
♦
TRUNKING SIDE
E&M channel 1: JP1, JP4, JP17, JP19, JP22
E&M channel 2: JP5, JP8, JP31, JP33, JP36
E&M channel 3: JP9, JP12, JP24, JP26, JP29
E&M channel 4: JP13, JP16, JP38, JP40, JP43
♦
SIGNALING SIDE
E&M channel 1: JP2, JP3, JP19, JP21
E&M channel 2: JP6, JP7, JP33, JP35
E&M channel 3: JP10, JP11, JP26, JP28
E&M channel 4: JP14, JP15, JP40, JP42
Type 2:
♦
TRUNKING SIDE
E&M channel 1: JP1, JP4, JP19, JP20
E&M channel 2: JP5, JP8, JP33, JP34
E&M channel 3: JP9, JP12, JP26, JP27
E&M channel 4: JP13, JP16, JP40, JP41
♦
SIGNALING SIDE
E&M channel 1: JP2, JP3, JP21, JP23
E&M channel 2: JP6, JP7, JP35, JP37
E&M channel 3: JP10, JP11, JP28, JP30
E&M channel 4: JP14, JP15, JP42, JP44
Type 3:
♦
TRUNKING SIDE
E&M channel 1: JP1, JP4, JP17, JP19, JP20
E&M channel 2: JP5, JP8, JP31, JP33, JP34
E&M channel 3: JP9, JP12, JP24, JP26, JP27
E&M channel 4: JP13, JP16, JP38, JP40, JP41