Keiser M3+ User And Service Manual - page 9
Mounting Handlebar Assembly
NOTE: IfinstallingtheM3computerpleasedosobeforemountingthehandlebars.Whenthecomputerinstallationis
completepleasereturntothisstep.
Step 1:Obtainthehandlebarassembly,6mmAllenwrench,andthesocketheadcapscrews(M8x1.25X12SS).Observe
the location of the two mounting flanges on the handlebar post. Place the handlebar assembly on the post mounts,
aligningthemountingholes.
Step 2:Tiltthehandlebarassemblyslightlytoplacethesocketheadcapscrews(M8x1.25X12SS)intothemounting
holes. Once each screw has been started, place the palm of one hand on the center of the handlebar pressing firmly and
evenlyontothehandlebarpost.WiththeotherhandtighteneachscrewwiththeAllenwrenchuntiltheheadofeachscrew
justmakescontactwitheachhole.Nowtighteneachscrewevenly.
Computer Battery Replacement
Totestthecomputerbatteriesrotatethecrank
armuntilthecomputer“wakesup”.Ifthebatteryis
low,a“LO-BA”willdisplayintheodometer(ODO)
displayatthebottomofthecomputer.Toreplace
thebatteriesunscrewthebackofthecomputer
housingandremoveoldAAbatteriesandreplace
withasetoftwonewAAbatteries.Ifyouhave
multiplebikes,wesuggestallcomputerbatteriesbe
changedatthesametime.
1
2
7