Kemper Profiling Amplifier Manual - page 15
FRONT PANEL CONTROLS
15
Type knob
(2)
When an effect or stomp is in the focus, the TYPE knob will select between different types of effect algo-
rithms. For example, in stomp edit this knob will select distortions, compressor and modulations among
others.
✔
✔
When you switch between similar effects types, you will notice that parameters common to these effects
will retain their values; this is to make the choice of algorithm easier. For example, you can make a dedi-
cated setting for a Wah effect, and then step through the various Wah types; the effect will change, but
settings for the various ranges and Wah pedal control will remain the same. You can also switch the type
between phaser and flanger, to check the different impact of these two algorithms, and the modulation
scheme will remain unchanged.
Browse knob
(3)
When you’ve got an effects module in focus, this knob selects between the local presets. In other words,
it chooses between different presets for distortion stomps, reverb settings, etc. When this knob is turned,
the display shows a list of available settings; and further turns will select between them. In Performance
mode, the BROWSE knob can be used to quickly browse the list of available performances. In Browse
mode this knob can be used to quickly browse the list of available rigs.
Page navigation
(4)
When a module is in focus, these buttons will switch between pages if more than one page is available for
a given module.
Exit button
(5)
This button is used to return to the “play” page. Also, you can use EXIT to cancel an operation.