Kemper Profiling Amplifier Manual - page 17

FRONT PANEL CONTROLS

17

Copy and paste buttons 

(8)

Use the COPY and PASTE buttons to grab a module and copy its data to another similar location. For 

example, you can copy and paste the settings of one stomp to another, either within the same rig, or an-

other rig entirely. To do this, select a module and press COPY. Next, select a destination module and press 

PASTE. Voilà!

In general, you can use common sense to determine if the KPA will let you copy settings from one module 

to another. For example, you cannot copy the reverb settings to the amp module. However, it is possible 

to copy a Stomp to slot X or MOD in the effects section. Go ahead and try whatever you want; you will be 

alerted if what you’re attempting is not possible.

Store button 

(9)

Use the STORE button on the left side of the display to save any changes you have made to a module or 

rig.

Pressing Store within an edit page will give you the option to save either the settings of the currently-

selected module as a local preset, or to save the entire rig. Make your choice and on the next page, choose 

between three different options using the soft buttons. “Replace” will overwrite the currently-selected 

rig with the new version. “Store as ...” will save the rig under a new name, and “Rename” will allow you to 

change the name of the rig, and then replace the current one with it.

In the next step you are able to edit the name of the rig.

Soft Button #1

Insert

 a space to the left of the selected character.

Soft Button #2

Clear

 the selected space or character.

Soft Knob #1

Toggle

 between upper case and lower case letters.

Soft Knob #4

Scroll

 through the available characters.

Press STORE again to complete the procedure.