Kemper Profiling Amplifier Manual - page 25

USING THE TUNER

25

Using the tuner

The tuner LEDs above the chicken head knob are always active so you can monitor your tuning while you 

play. Even when you’re not in tuning mode, the LEDs give you general information whether your guitar is 

in tune or not. If a guitar string is far out of tune, only the outer LEDs will be on. If your string is closer to 

proper tuning, the middle LED gets brighter. If your string is in tune, only the middle LED will be lit. So to 

tune your strings, make sure that the white LED in the middle is on, and the surrounding green LEDs are 

both off.

If you want a far more advanced tuner, you can use the chicken head knob to activate Tuner mode. When 

Tuner mode is engaged, a large tuner graphic appears and addition, unique tuner functions become avail-

able:

Mute Signal

This determines whether the audio is sent to the MASTER OUTPUTS or not. To tune 

your guitar silently, enable “Mute Signal”. The signal will then be muted, but only 

while you’re in Tuner mode. This is a neat way to mute the signal temporarily; for 

example, to avoid unwanted noise when you change guitars.

Master Tune

Use “Master Tune” to adjust the base pitch of the tuner, in case you need to tune 

your guitar to something other than 440 Hz.

✔

✔

When the Tuner mode is enabled, the LEDs become more sensitive to softer levels.