La Marzocco Linea PB Manual - page 63
EN
63
Display
Operating Procedure
Description
Programming Mode
(only on AV and ABR espresso machine models)
“Technical” Programming
After accessing the “Technical” programming menu and entering the password, use the buttons T1
and T2
until the following screen is displayed.
Press the T3 button
to enter the doses programming procedure.
Press the T3 button
to start the doses programming procedure.
On each button you can set two doses, one for a short shot, one for a long shot.
To set the brewing time of a short shot, press and release the button immediately, press again to stop and store
the desired dose.
To set the brewing time of a long shot, press and hold the button for about 2 seconds, press and release the
button immediately to store the desired dose.
The two doses of each key can be set independently from one another.
If one of the two doses is not set or does not refer to the corresponding dose of the first group, it will work as
continuous dose.
• This parameter allows the operator to
program the amount of coffee (brewing
amount) for each button on the
keyboard.
• The brewing amount can be set in terms
of time (sec. ) or pulses. This number
refers to the number of pulses that the
flowmeter sends to the CPU.
• Once programmed, the button remains
lighted.
• It is possible to set the dose for both a
short and a long shot on the same key.
• The setting of the first group is
automatically copied to the subsequent
groups.
• It is possible to set each key individually,
in this case the dose of the first group
will no longer be used.
• It is possible to copy the doses of any
key to the others.
Group Dose
Settings
Group Dose
Settings
LaMarzocco 00:00
CB 93.8
°C SB
Program Dose
Push To Stop
20 Pulses 1s
Press Enter
To Exit
G1B1 Saved
20 Pulses
Program
Volume Dose
1
2
3
4