La Marzocco Linea PB Manual - page 83
EN
83
Display
Operating Procedure
Description
Programming Mode
“Technical” Programming
Press the T3 button
to enter the menu, move with the buttons T1
and T2
to set the
desired temperature, press the T3 button
to confirm the value. In the case of espresso machine with 4
groups you can set this value also on the coffee boiler 2.
Press the T3 button
to return to the “Technical” programming.
Press T1
or T2
to continue with the programming of the other parameters.
To exit the menu move between the parameters using the buttons T1
and T2
until the exit menu
is displayed. Press the T3 button
to exit the menu and return to the normal use of the espresso machine.
Alternatively, you can exit the “Technical” programming and return to the normal use of the espresso machine
by pressing T2
and T3
at the same time.
Coffee Boiler
Settings
Coffee Boiler
CB1 Offset
3.0
°C
• The OFFSET parameter is used to
calibrate the coffee boiler temperature
system to ensure the display temperature
accurately represents the temperature
of the water exiting the group head.
• This parameter is preset at the factory
based upon initial tests of this espresso
machine.
• It is not recommended that this number
is changed. Changes to this parameter
can cause unexpected results.
• It is important to write down this value
before making changes to be sure you
can return to the factory programming if
unexpected results occur. Each machine
may have a different value as it is set
individually.
THE STEAM BOILER CONTAINS WATER AT ELEVATED TEMPERATURES.
WATER TEMPERATURE OVER 52°C CAN CAUSE SEVERE BURNS INSTANTLY OR DEATH FROM SCALDING.
DANGER
CB Settings
Exit
LaMarzocco 00:00
CB 93.8
°C SB
Exit
Menu
5
8
9
6
7