La Spaziale S1 Vivaldi II Owner's Manual - page 9
S1 Vivaldi II Owner’s Manual
3. The
BOILER
button can also be used to switch in and out of Economy mode. In
this mode only one boiler can be on at a time. The VII automatically controls
which is on according to demand with preference going to the group boiler. This
e owning the 20A model but lacking a 20A circuit.
is useful for thos
4. Turning the Steam/Hot Water Boiler On and Off
1. The VII must be in ON mode, not Standby for all operations below.
2. Momentarily press the
BOILER
button
3. The Boiler lamp turns off. Neither steam nor hot water is available.
then On again, or if power is removed and restored to
Note: if you turn the VII Off
the VII, the Boiler returns to the On state.
4. Momentarily press the
BOILER
button again.
lamp is on (or blinking). Steam and hot water are available.
5. The BOILER
Turning Economy Mode On and Off
1. The VII must be in ON mode, not Standby for all operations below.
2. Press the
BOILER
button for 10 seconds until the ECON lamp illuminates.
ff and On again or if power is removed and restored to
Economy mode is now active.
Note: if you turn the VII O
the VII, Economy mode remains active until you perform step 4, below.
3. While in Economy mode you can momentarily press the
BOILER
button to
completely turn off the boiler. Another momentary press returns you to Economy
mode.
4
y mode, press and hold the
BOILER
button for 10 seconds until
3.9
ckward compatible mode that emulates the
e advanced features of the VII are available
doubt
e you are in, just unplug the VII and then plug back in to see if the three
llow = VII mode and Green = VI mode.
. To exit Econom
the ECON lamp is extinguished.
V1/VII Mode Switch
The VII Controller board actually has a ba
unctionality of the original VI. None of th
f
when the controller is in VI mode. If you don’t seem to be able to access the VII
features, your machine might have inadvertently gotten switched to VI mode. If in
as to which mod
yellow or three green lamps blink once. Ye
W
b
ith the VII in Standby mode (ON/STBY blinking green), press and hold the
Hot Water
utton for at least 10 seconds. If three yellow lights blink once your machine is now in
VII mode. If three green lights blink once the machine is now in VI mode. Each time
you hold in the
Hot Water
button for 10 seconds while in Standby (ON/STBY blinking
green), the mode toggles.
gs
Note that if you change from VII mode and then back again all the V2 specific settin
are lost and must be reset.
Page 7