Labgear S401 User Manual - page 3
2 Introduction
Thank you for choosing the Labgear S401, a great aid to satellite dish and LNB alignment,
pre-loaded with masses of data and tools to make your job simpler and quicker.
Before you start please take time to read through this instruction leaflet which we hope will help
you get the most out of your meter.
3 Key Features
• Digital Satellite Meter compatible with DVB-S and S2 and DiSEqC 1.0/1.1/1.2 with 22kHz tone
• Displays both signal strength and signal quality with sound and light alarms to aid alignment
• Computes Azimuth, dish Elevation and LNB Polarisation angles for all satellites based on
your location
• Stores information on 100 of the most popular satellites worldwide
• LNB short circuit protection built-in
• Includes magnetic compass to assist alignment
• 7.4V/3000mAh rechargeable Li-Ion battery and mains power charger included
• Easy to carry with protective sleeve and shoulder strap
• Software upgrades possible from a PC using the USB port and cable supplied
4 Pack Contents
Supplied with:
Supplied with:
1x Carrying Case with Shoulder Strap
1x Mains Charger
1x Car Charger
1x Jack to 3 Phono AV Lead
1x User Guide
5 Battery Charging
1. Ensure that the meter is switched off. Connect the charger plug to the charging socket (5)
on the right hand side of the meter.
2. Plug the charger into a mains socket the charging LED indicator (15) will light up green.
3. When the battery is fully charged, the charging LED indicator (15) will go out.
4. Unplug the charger from the mains socket and disconnect the charger from the meter.
Do not leave the meter unsupervised when charging is taking place.
S401
- Introduction and Features
3