Lampert PUK D3 Operating Manual - page 21
© Lampert Werktechnik GmbH
2017
20
10.2 MICROSCOPE
PROBLEMS WITH ELECTRICAL COMPONENTS
A
The LED illumination fails to
operate
Cable not connected.
Connect the plug to the connecting
socket (3) marked with the red and
yellow eye protection and illumination
symbol on the PUK.
LED faulty
Contact authorized customer service
B
Eye protection system (shutter)
fails to operate
Cable connected incorrectly
Connect the plug to the connecting
socket (3) marked with the red and
yellow eye protection and illumination
symbol on the PUK.
Eye protection filter faulty
Arrange to have eye protection unit
replaced by qualified personnel
IMAGE QUALITY
D
Poor resolution
Oculars dirty.
Clean oculars.
E
Marks or soiling in field of vision
Oculars dirty.
Clean oculars.
Protective glass dirty
Clean or exchange protective glass
* Note: Marks in the field of vision can also be caused by soiling in the interior of the oculars. For this reason, it is
recommended to have the lenses cleaned by an authorised customer service engineer
PROBLEMS WITH MECHANICAL COMPONENTS
F
Focus is not retained
The sight slides down
Readjust the tension of the focusing
knob
REPAIR
If the PUK D3 or the stereo microscope should require a
repair or adjustment by qualified personnel, we always
recommend to first contact your dealer or an authorized
customer service.
WARNING: THE DEVICE MAY ONLY BE OPENED BY A QUALIFIED ENGINEER!
11. SPARE PARTS LIST, SEE ALSO www.lampert.info
Handpiece
(37)
Nozzle (Ø 3 mm)
(38)
Clamping nut
(39)
Chuck Ø 0.5/0.6 – 0.8 mm
(40)
Handpiece complete
Gas hose:
6 x 4 mm, sold by the metre
100 150K
100 152
100 15x
100 100 04
100 153
PLEASE NOTE!
Nozzle
(37), clamping nut (38), electrodes and clamping tongs (39) are wearing parts and are not covered by the
guarantee.
40
38
39
37