Lanier R/C BF109 Building Instructions - Warbird Combat
Warbird Combat
Assembly instructions
14
fit here
Pull the crutch sides in against the
motor mounts making sure they fit in
the cutout. Glue the sides to the
mounts starting at the nose. Glue
the mounts to the nose ring. Work
from the front to the back gluing
the sides to the center support.
After the sides are glued to the cen-
ter support, glue the sides to the
fuselage in the wing saddle area.
Make sure the plane is sitting on a
flat surface and press the sides
down into the wing saddle so as not
to warp the fuselage.
Glue the rear portion of the center
support to the plastic behind the
fuse sides.
glue here
Glue the elevator servo mount in
place on the marks on the fuse cen-
ter section.
The top half of the fuselage over-
laps the bottom half 1/4” Clip the
corners of the bottom half of the
nose ring 1/4” to allow the top to fit
forming the 2” nose ring.
clip here
Mark the tail of the fuselage bottom
at the top of the angle and cut along
the line. This leaves a 3/8” flange to
mount the fin.