Lanier R/C BF109 Building Instructions - Warbird Combat
Warbird Combat
Assembly instructions
19
6. The tank will slide into the fuse
over the throttle servo and fit
between the wooden rails. Push it
all the way forward and the protru-
sion on the bottom of the tank will
fit against the rear of the motor
mounts.
Elevator pushrod
1. Locate the 2-56 x 15” pushrod and
make a 90 degree bend 7” from the
threaded end. Cut the rod off at
1/8”.
threads
7”
2. Locate the 1/4” x 11” wooden
dowel. Drill a hole(.078”) in each end
1-1/4” from each end. Use an e-xacto
knife to cut a slot from the hole to
the end of the dowel that will
accept the 2-56 wire.
3. Insert the angled end of the eleva-
tor wire into the hole in the end of
the dowel and press into the slot.
Wrap the wire with string and glue in
place with CA.
4. Take the piece of wire you cut from
the elevator pushrod wire and bend
a 90 degree angle in the end 1/8”
long. Insert it in the other end of
the dowel and wrap and glue it in
place.
5. cut a slot 3/4” long and 3/32”
wide in the rear of the fuselage on
the same side as your elevator horn
for the pushrod to exit. It should be
centered on the front edge of the
stab and just below the seam in the
fuselage.