Lanier R/C BF109 Building Instructions - Warbird
Warbird
Assembly instructions
5
Make sure the left and right panel
are perfectly aligned with each
other and laying flat on the table.
Lay a piece of wax paper over the
center of the root so the glue does
not stick the panel to the table when
gluing together. Mix some 5-minute
epoxy and spread on the root of both
wing panels. Place the panels flat
on the table with the tip blocked up
and use masking tape to hold the pan-
els together till the epoxy sets
The wings are flat bottomed, Lay the
cores on a flat surface with the
roots butted together, if your table
is not straight your wings will not be
straight. You may have to shim one
side to make sure the two halves are
perfectly even with each other.
Layout the position of the aileron
servos on each wing panel. The front
edge of the servo should be 1” behind
the spar. The servos should be out
from the center of the wing by the
length of the servos wire.
Use a sharpie marker and mark
around the servo and down the
length of the wire.
slot for wire