Lanier R/C BF109 Building Instructions - Warbird Combat
Warbird Combat
Assembly instructions
16
When satisfied with the fit, start
gluing in the middle of the fuse over
the wing saddle. Work from the mid-
dle to the tail then from the middle
to the nose. A large squeegee work
well to hold the seam down while
applying thin CA along the seam.
After both sides are glued down, use
an x-acto knife and cut the plastic
out of the nose ring and the engine
opening.
Cut the plastic away in the wing sad-
dle. Cut at the bottom of the flange
which leaves a lip rolled over the
edge of the 1/8” fuselage sides.
Mark the location of the dowel
holes by reaching inside the fuse and
pushing a sharp piece of wire
through the hole in the plywood
fuselage side. Drill the plastic using
a 9/32” drill and install the epoxy
glass dowels. Glue in place with CA.