Lantronix Com Port Redirector Quick Start Manual - page 5
4
9. Click
the
Close button.
Device Server Configuration Guidelines
Observe the following general guidelines when preparing the device server for use with Com
Port Redirector:
The device server to which Com Port Redirector will connect must have an IP address.
The PC running Com Port Redirector must have a good network connection to the device
server.
If redirecting over a Wide Area Network (WAN), both the PC and the device server must
have a correct gateway address configured in their TCP/IP settings.
Serial settings on the device server must match the settings of the serial device when
RFC2217 is not implemented. Serial settings include:
-
Baud rate
-
Parity
-
Stop bits
-
Flow control
-
Interface mode (RS-232 or RS-422/485)
Consult your device server documentation for information about configuring these
serial settings for your device server.
Connect/Disconnect and Access Modes: You must configure the way the device server
accepts a connection appropriately for the device server to accept a network connection
from Com Port Redirector.
-
CoBox, UDS, XPort, and XPress products: Set the Connect Mode to C0 and
Disconnect Mode to 00. If the CPR com port is set for Listen Mode, set the
Connect Mode to 05.