LCG LCG-2501WB User Manual - page 12
LEAD PACK 1(
LCG-2501WB)-User Manual
12
POW(Power reduction) xxx%
LOAD(Load)
ST L(Setting load)
YES/NO
PR L(Program load) YES/NO
Instructions:
When enter to the “*” position displayed on the LED. When power cycle it will jump to the “*” position and
running again. And in these position it will not return back to the default display after two minutes.
6.1 DMX ADDRESS SETTING
1) Press the 【ENTER】 button in 【ADDR】 menu, then enter to the DMX address setting.
2) Press the【UP/DOWN】button to select【1-512】numerical value.
3) Press the【ENTER】button to escape and save.
6.2 STATIC SETTING
1) Press the【ENTER】button in 【STAT】menu, then enter to the static setting.
2) Press the【UP/DOWN】 button to select 【RED】,【GREEN】,【BLUE】,【AMBER】,【WHITE】
and【SHUT】.
3) Press the【UP/DOWN】button to set up the【0-255】numerical value.
4) Press the【ENTER】button to escape and save.
6.3 Wireless set
1) Press the【ENTER】button in【WIRE】menu, then enter to the wireless set.
2)【RESET】Simulating the power outage of wireless module and then press the button to power on
3)【KEY】Similar to an external button
6.4 Battery output setting
1) Press the【ENTER】button in【BAT】menu, then enter to the Battery output setting.
2) Press the【UP/DOWN】button to select【HIGH】,【MIDDLE】, 【LOW】
3) Press the【ENTER】button to escape and save.
6.5 COLOR CAST CALIBRATION SETTING
1) Press the【ENTER】button in 【CAL】menu, then enter to the color cast calibration setting.
2) Press the【UP/DOWN】button to select 【RED】,【GREEN】...【WHITE】
3) Press the【UP/DOWN】button to set up the【0-255】numerical value.