Leadtek WinFast 6200MA User Manual - page 36
Leadtek Research Inc.
32
PM Control by APM
If Advanced Power Management (APM) is installed on your system, selecting Yes gives better
power savings.
The choice: Yes, No.
Video Off Option
Selects the power-saving modes during which the monitor goes blank:
Always On
Monitor remains on during power-saving modes.
Suspend -- Off
Monitor blanked when system enters Suspend mode.
Susp, Stby -- Off
Monitor blanked when system enters either Suspend or Standby mode.
All Modes -- Off
Monitor blanked when system enters any power saving mode.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank
This selection will cause the system to turn off the vertical
and horizontal synchronization ports and write blanks to the
video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS Supported
Select this option if your monitor supports the Display
Power Management Signaling (DPMS) standard of the
Video Electronics Standards.
Switch Function
You can choose whether or not to permit your system to enter complete Suspend mode. Suspend
mode offers greater power savings, with a correspondingly longer awakening period.
Break/Wake. System enters Suspend mode; press the power button again to return to full power.
The choice: Break/Wake, Disabled.
Doze Speed (div by)
Select a divisor to reduce the CPU speed during Doze mode to a fraction of the full CPU speed.
Stdby Speed (div by)
Select a divisor to reduce the CPU speed during Standby mode to a fraction of the full CPU
speed.
MODEM Use IRQ
Name the interrupt request (IRQ) line assigned to the modem (if any) on your system. Activity
of the selected IRQ always awakens the system.
The choice: 3, 4, 5, 7, 9, 10, 11, NA.
Hot Key Function As
Select Enabled if your system has a hot key for soft power off.
The choice: Enabled, Disabled.
** PM Timer **
HDD Off After
After the selected period of drive inactivity, the hard disk drive powers down while all other
devices remain active.
By default, this item is Disabled, meaning that no matter what the mode
the rest of the system is the hard drive will remain ready. You also have a range of choices from