Leadtek WinFast 6200MA User Manual - page 50
Leadtek Research Inc.
46
Step 4
Select the “Change” button in the “Adapter Type” section, a window with a title
name of “Change Display” will appear on your screen.
Step 5
Select the “Have Disk” button where the “Install From Disk” window will then
appear on your screen.
Step 6
Specify the path X:\winnt40 (X means CD-ROM drive name) and select the “OK”
button in the “Install From Disk” window; a window with a title name of “Third
Party Drivers” will then appear on your screen, select the “Yes” button.
Step 7
Click the “OK” button after the installation is complete and select the “Close”
button in the “Display Type” window. Select the “Close” button in the “Display
Properties” window.
Step 8
Click the “Yes” button to restart the Windows NT 4.0.
Step 9
When the system is rebooted, select “Windows NT 4.0” from the Boot Menu List.
After logon Windows NT, the “Invalid Display Setting” applet will appear on
your screen.
(NOTE: This window will only appear when you are using the new display drivers for the first
time).
Choose the resolution, color palette, refresh rate and font size you desire. You can use the
“TEST” button to verify whether the monitor can support the specified resolution and refresh
rate or not.
Press the “OK” button to change display mode to the specified resolution, color palette, refresh
rate and font size.
5-3
Installing Audio Driver for Windows 95/98,Windows
NT 4.0
Step 1
Insert the “WinFast Mainboard & SCSI Software Pack CD” into the CD-ROM
drive.
Step 2
The “Autorun” will be automatically executed and “WinFast-6200 Setup”
window will appear on screen with selectable menus.
Step 3
Select and click “WinFast 6200 ESS Solo1 Audio Driver”. You will see a popup
menu showing “For Windows 95/98” and “For Windows NT 4.0”. Select the
desired operating system and click.
Step 4
Select “Upgrade” and desired language. Windows will automatically copy files
from CD to your hard drive. These are necessary files for installation of Audio
drivers to your system. After finishing copying files, Click “Yes” to restart your
computer.
Step 5
A dialog of “Found Hardware (ESS Solo1 PCI Audio Drive)” will be shown on
the screen. Just keep clicking the “Next” buttons that follows, Windows will
automatically install the Audio Drivers to your system.