Leaf AFi Quick Start Manual - page 80

16

 Chapter 2 – Getting Started

Removing the AFi Back

The Leaf AFi digital camera is provided with the back attached to the 

camera, and does not need to be assembled. If you wish to remove the 

back, do the following:

¾

Holding the AFi camera securely, push the back release inwards and 

upwards, and gently pull the AFi back away from the camera body.

Note:  It is highly recommended to use the covers provided to protect the back 

of the camera and the front of the AFi back when not in use.

Rotating the AFi Back

1.

Holding the AFi camera securely, push the back release inwards and 

upwards, and gently pull the AFi back away from the camera body.

2.

Rotate the AFi back counterclockwise by 90°.

3.

Line up the AFi back and the camera.

4.

Insert the pins of the AFi back into the holes on the rear end of the 

camera. 

5.

Hold the back parallel to the body, and push the back and the camera 

together making sure that each pin is locked at the same time. 

Tip:  When the back is detached from the camera and not in use, please use the 

protection cap.