©ledion ltd 2004 tel: +44 (0)116 278 8078 http://www.Ledion.Com lud 36 installation manual - issue 2.0: sept 2004 installation manual lud 36 power supply.
Page 2 page 19.
Page 18 worldwide sales offices. Uk and europe. Ledion ltd, westfield, rear of 24-26 leicester road, blaby, leicester. Le8 4gq. Tel: +44 (0) 1162 788078 fax +44 (0) 1162 771286 www.Ledion.Com sales@ledion.Com usa / canada. Ledion inc, 1930-1 north commerce parkway, weston, florida. Fl 33326. Tel: +1...
Page 4 guided tour of the lud 36 1. Power on (green) led. (seen through side casing). 2. Mains input. 90v – 250v ac 3. Led output socket. The led fixtures are connected to this socket with rj45’s. (max load 36 led’s.) 4. Dmx out/thru socket. Connects rj45 data cable to input of next dmx unit. (when ...
Page 16 trouble shooting for further assistance contact, info@ledion.Com page 5.
Page 6 dmx addressing this power supply requires 4 channels of dmx for each unit on the dmx line. This unit can be individually addressed using the dipswitches (see page 4 fig 1.1 no 6) to give you individual control over an amount of power supplies. Note you will not have individual control over th...
Page 14 ending cat5e cable if you are using your own cat5e cable and want to make off the ends yourself the following diagram must be used to carry out that process. (fig 1.6) note. Some cat5 cable is not stranded, it is solid core, and you must make sure you have the correct rj45 socket. We recomme...
Page 8 table 2. Dipswitch settings colour cycle time 10+9+1 red static 10+9+2 green static 10+9+3 blue static 10+9+4 amber static 10+9+5 cyan static 10+9+6 magenta static note: the following settings are best achieved when using the ledion ultra products fitted without optics, which are more suitabl...
Page 12 fig 1.4 page 9 table 3. Dipswitch setting colour cycle time 10+8 on scrolling pastel 2 secs 10+8+1 scrolling pastel 5 secs 10+8+2 scrolling pastel 10 secs 10+8+3 scrolling pastel 30 secs 10+8+4 scrolling pastel 2 mins 30 secs 10+8+5 scrolling pastel 5 mins 10+8+6 scrolling pastel 20 mins 10+...
Page 10 typical wiring diagrams fig 1.2 page 11 fig 1.2 shows a typical set-up of ledion lu3’s, lu6’s or lu12’s all fixtures should be connected to the lud36 power supply with rj45 data cables into the lut (tee piece), (see fig 1.3) the fixture is then plugged into the port marked led, the cable com...
