Ledion LUD 36 Installation Manual - page 7
Page 14
Ending CAT5e Cable
If you are using your own CAT5e cable and want to make off the ends
yourself the following diagram must be used to carry out that process.
(Fig 1.6)
Note. Some CAT5 Cable is not stranded, it is solid core, and you
must make sure you have the correct RJ45 socket. We recommend
only using stranded cable.
If you are buying pre-ended cables from another supplier, you must use
(CAT5e PATCH) cables, the cable should have this printed on it,
alternatively we will supply you with the correct cable and lengths to
suit your requirements.
Page 7
Setting up
The power supply is connected to all LED fixtures by linking RJ45 CAT 5
Data cables into each fixture.
Typical system examples for the entire Ledion Ultra range.
(See Pages 9-13)
Setting the dipswitches for stand-alone programs
.
Table 1.
Dipswitch Setting
Colour
Cycle Time
10 on
Scrolling RGB
2 secs
10+1
Scrolling RGB
5 secs
10+2
Scrolling RGB
10 secs
10+3
Scrolling RGB
30 secs
10+4
Scrolling RGB
2 mins 30 secs
10+5
Scrolling RGB
5 mins
10+6
Scrolling RGB
20 mins
10+7
Scrolling RGB
1 hour
Note.
RGB signifies that all the colours used are mixed at full strength and
brightness.