Ledion LUD 36 Installation Manual - page 6
Page 6
DMX Addressing
This power supply requires 4 channels of DMX for each unit on the DMX
line. This unit can be individually addressed using the Dipswitches (see
page 4 fig 1.1 no 6) to give you individual control over an amount of
power supplies. Note you will not have individual control over the LED
fixtures on a single power supply, regardless of the number fixtures
plugged into the unit, will all do the same thing.
Channel 1 = Red
Channel 2 = Green
Channel 3 = Blue
Channel 4 = Dimmer
Note. The dimmer Channel must be over DMX value 10 out of 255 to
illuminate the LED’s.
Example Dipswitch Settings.
Page 15
DMX OPERATION
To run this unit via DMX 512 you must have a converted data cable that
is either a 3 pin or 5 pin XLR. The DMX cable should be connected from
either the DMX desk or other DMX device to the DMX IN socket, which is
indicated on the end of the unit. If you are making your own cable the
wiring diagram below must be used. CAT5e cable must be used to make
this lead.
Fig 1.5
If this unit is to be used in the middle of a DMX line For example
you will need two converted cables one IN and one OUT, to connect
from the first DMX device to the power supply and out into the next
DMX device.