LEEDS WORLD PTZPRO 12 User Manual - Dome : Motion
26
OPERATION & PROGRAMMING
DOME : MOTION
PROPORTIONAL PAN/TILT
Proportional pan/tilt automatically reduces or increases the pan
and tilt speeds in proportion to the amount of zoom.
At telephoto zoom settings, the pan and tilt speeds will be
slower for a given amount of the joystick deflection tan at wide zoom settings.
There are two proportional pan/tilt modes:
ON (default) Enables the proportional pan/tilt mode.
OFF Disables proportional pan/tilt mode. The pan/tilt speed
will not depend on the amount of zoom.
AUTO FLIP
When the camera tilts downward and goes just beyond the vertical position,
the dome rotates 180 degrees. When the dome rotates (flips), the camera starts
moving upward as long as you continue to hold the joystick in the down position.
Once you let go of the joystick after the dome rotates, joystick
control returns to normal operation.
ON (default) Auto flip mode is enabled.
OFF Auto flip mode is disabled.
OVER TILT
To prevent horizontal view cut with trim ring or ceiling, this
menu restrict horizontal view angel.
ON restrict minimum tilt angle to -1.8 degree
OFF restrict minimum tilt angle to 4.5 degree.
AZIMUTH ZERO
Azimuth zero is the pan angle from 0° to 359°. Azimuth zero is the pan position you
specify to be the 0° point. Azimuth zero is normally set to magnetic north.
Once set, azimuth is based on the set Azimuth zero point.
To set Azimuth zero :
1. Use the joystick to position the cursor beside AZIMUTH ZERO.
2. Press [TELE] or twist the joystick clockwise.
3. Follow the directions displayed on the monitor.
To clear Azimuth zero :
1. Use the joystick to position the cursor beside AZIMUTH ZERO.
2. Press [WIDE] or twist the joystick counterclockwise.
LIMIT STOP
Limit stops are programmable stops that limit the pan range of the dome.
There must be two limits, a left and a right, to define an area,
A manual(joystick) pan operation stops when a limit stop is reached.
To set limit stops :
1. Use the joystick to position the cursor beside LIMIT STOP.
2. Press [TELE] or twist the joystick clock wise.
3. Follow the directions displayed on the monitor.
To clear limit stops, set limit stop mode to OFF.
1. Use the joystick to position the cursor beside LIMIT STOP.
2. Press [WIDE] or twist the joystick counterclockwise.
>
██████████████████████████
PROP. PAN/TILT: ON
AUTO FLIP : ON
OVER TILT : ON
AZIMUTH ZERO : OFF
►LIMIT STOP : OFF
-LEFT LIMIT :
-RIGHT LIMIT :
██████████████████████████
>>>>
██████████████████████████
SYSTEM >
DISPLAY > GENERAL
►DOME > ►MOTION
CAMERA > HOME
ALARM
PRESET
EXIT
TOUR
PATTERN
SCAN
>
██████████████████████████
►PROP. PAN/TILT: ON
AUTO FLIP : ON
OVER TILT : ON
AZIMUTH ZERO : OFF
LIMIT STOP : OFF
-LEFT LIMIT :
-RIGHT LIMIT :
██████████████████████████