LEEDS WORLD PTZPRO 12 User Manual - Dome : Home
27
OPERATION & PROGRAMMING
DOME : HOME
This feature defines the activity which is set should be executed
after assigned idle time.
ACTION / NUMBER
PRESET [NUMBER] Dome goes to preset [NUMBER].
TOUR [NUMBER] Runs tour [NUMBER].
PATTERN [NUMBER] Dome starts pattern [NUMBER].
SCAN [NUMBER] Dome goes to scan [NUMBER].
Note
-In order to call action preset, tour, pattern or scan, you must
save preset, tour, pattern or scan first.
TIME
This feature allows the dome to begin a user specific action
after a programmed time of inactivity. Home time can be
programmed from 1 minute to 240 minutes (4 hours).
MODE
AUTO : Enabled HOME function.
MANUAL(default) : Disables this feature.
>>>>
██████████████████████████
SYSTEM >
DISPLAY > GENERAL
►DOME > MOTION
CAMERA > ►HOME
ALARM
PRESET
EXIT
TOUR
PATTERN
SCAN
>
██████████████████████████
►ACTION
: HOME
NUMBER :
TIME
: 120 min
MODE
: MANUAL
██████████████████████████
DOME : PRESET
The dome system can have maximum 256 preset positions.
Use the following steps to program a preset.
1. Press the MENU key (refer to ‘Accessing main menu’).
2. Select DOME and select PRESET using joystick.
3. Select the preset number.
a. Use the joystick to position the cursor beside NO.xxx. Move
Left or right to select preset ID.
b. Press the [TELE] button or turn the joystick clockwise to setupAngle.
Follow the directions displayed on the monitor to edit the preset scene.
4. Edit the preset label. Refer to TITLE:EDIT section on this manual.
5. Edit the dwell time.
6. Save the settings.
To disable or clear a PRESET :
1. Use the joystick to position the cursor beside NO.xxx.
Move left or right to select preset ID.
2. Press the [WIDE] key or turn the joystick counterclockwise to clear.
Note
-Press [ENT] or [OPEN] key to save settings and exit to previous
menu or Press [Esc] or [CLOSE] key to exit to previous menu
without saving any settings at any time.
>>>>
██████████████████████████
SYSTEM >
DISPLAY > GENERAL
►DOME > MOTION
CAMERA > HOME
ALARM
►PRESET
EXIT
TOUR
PATTERN
SCAN
>
██████████████████████████
►NO.001 :
Saved
TITLE
:
DWELL
:
-PTZ
:
██████████████████████████
Press
Press
* Start Position Setup
* Press MOVE Key
* Save:
* Exit: