Logic L60CHDB10 Instruction & Installation Manual - Mounting The Cooker Hood

16

 Mounting the Cooker Hood

1.  A 125mm hole will need to be provided for the aluminium flexible hose (not supplied) to duct the extracted 

air to the outside. For recirculation operation, a competent person can follow the instructions below.  If you 

are in any doubt, we recommend you consult a qualified technician.

2.  Ensure there is an available switched electrical socket adjacent to the hood to power the appliance. If this 

is not available, do not use extension leads. We recommend you consult a qualified electrician prior to 

commencing any work.

3.  Offer the appliance to the wall surface ensuring the 

minimum dimensions are met (650 mm for electric hobs 

and 750 mm for gas) and ensure the appliance is level. Mark 

the two keyhole points on the top of the hood.  Using a 10 

mm drill bit and ensuring there is no pipe work or wires 

buried in the wall drill the two holes to a sufficient depth to 

insert two of the 10 mm wall fixings flush into the wall.

For L60CHDX10 & L60CHDB10

150

240

183

A

B

C

D

min. 650

min. 750

ELECTRICITY

GAS

For L90CHDX10

600

183

C

D

ELECTRICITY

GAS

150

A

B

min. 650

min. 750

•  We recommend that a qualified technician is consulted prior to the fitting of this appliance.

•  Each installation is different and these instructions should be used as a guide only.

•  Air must not be discharged into a flue that is used for exhausting fumes from appliances burning 

gas or other fuels.