Magellan MG5000 User Manual - Instant Arming
Magellan
3
Instant Arming
After Stay arming the system and during its Exit Delay,
press
and hold the
[
STAY
]
key for 3 seconds
.
You should hear a confirmation
beep. The system is then Instant armed. Therefore, any armed zone that is breached will immediately generate an alarm.
If you have access to both partitions:
One-Touch Arming
One-Touch arming allows you to arm the system without using an access code. This feature must be enabled by your installer.
If One-Touch Arming is programmed, you can increase the security level of your system (from Disarm
Stay Arm
Sleep Arm
Full Arm)
without a code. See Figure 3 on page 6.
One-Touch Regular Arming
Press and hold the
[
ARM
]
key for 3 seconds to arm all zones in the partition. If partitioned, keys
[1]
&
[2]
will flash. You can use this
feature to allow specific individuals like service personnel (i.e. cleaners) to arm without giving them access to any other alarm
system operations. For details on Regular arming, refer to page 4.
One-Touch Stay Arming
Press and hold the
[
STAY
]
key for 3 seconds to arm the perimeter (zones not defined as Stay zones). For details on Stay arming,
refer to page 4.
One-Touch Sleep Arming
Press and hold the
[
SLEEP
]
key for 3 seconds to arm all zones not defined as Sleep zones. For details on Sleep arming, refer to page
4.
One-Touch Bypass Programming
Press and hold the
[
BYP
]
key for 3 seconds to access Bypass Programming Mode. For details on Bypass Programming, refer to
page 7.
Fast Exit
When the system is already Stay or Sleep armed: This feature will allow you to exit already armed premises and keep the system
armed.
Exit and Stay Arm:
Press and hold the
[
STAY
]
key for 3 seconds to start the Exit Delay (see page 16). After the Exit Delay has elapsed, the system
will return to Stay arming.
Exit and Regular Arm
Press and hold the
[
ARM
]
key for 3 seconds to start the Exit Delay (see page 16). After the Exit Delay has elapsed, the system will
switch to Regular arming.
Exit and Sleep Arm
Press and hold the
[
SLEEP
]
key for 3 seconds to start the Exit Delay (see page 16). After the Exit Delay has elapsed, the system
will switch to Sleep arming.
To Instant arm one partition:
To Instant arm both partitions:
1. Press the
[
STAY
]
key.
2. Enter your
[
ACCESS
CODE
]
.
3. Choose a partition. Press
[1]
or
[2]
.
4. Press the
[
CLEAR
]
key.
5. Press and hold the
[
STAY
]
key for 3 seconds.
1. Press the
[
STAY
]
key.
2. Enter your
[
ACCESS
CODE
]
.
3. Press
[1]
.
4. Press
[2]
.
5. Press and hold the
[
STAY
]
key for 3 seconds.