Magellan MG5000 User Manual - Auto-Arming
4
User Guide
Figure 3
Auto-Arming
The Magellan alarm system can be programmed to automatically arm upon the following two conditions.
Timed Auto Arming
The alarm system can automatically arm itself at a specified time everyday. As with Regular arming (see page 4), the system will not
arm if a zone is open. If this occurs, the system will not arm until the next day. Your installer can enable this option, but you can
program the time of day the system will automatically arm.
No Movement Auto Arming
The alarm system can be programmed to arm the system and/or send a report if no zone activity occurs for a pre-programmed
amount of time. This is a particularly useful feature when supervising an individual with chronic health problems or a person who
lives alone. This feature must be set by your installer.
Disarming & Deactivating an Alarm
To disarm an armed system or an alarm, enter your access code. An entry point, like the front door, will be programmed with one of
two Entry Delay Timers. When an entry point is opened, the keypad will beep until you disarm the system. Your alarm system will not
generate an alarm until this timer elapses. Any user can disarm a partition they have been assigned to, except users assigned with
the Arm Only Option or PGM Only Option.To disarm alarms generated by a
Delayed Fire Zone,
please refer to
Fire Alarms
on page
7.
How do I program the Auto-Arm Timer?
1. Press the
[ ]
key.
2. Enter
[
MASTER
CODE
]
.
3. Press the
[
BYP
]
key. The
[
BYP
]
key will flash to indicate you are in the System Options menu.
4. Press key
[1]
to set partition 1, or press key
[2]
to set partition 2.
5. Enter the desired time for auto arm (24 hour clock, e.g. 18:30).
6. Press key
[1]
to regular arm, key
[2]
to sleep arm, or key
[3]
to stay arm the partition.
How do I disarm the system?
For a Stay, Sleep or Instant armed system, go to step 2.
1.
Enter through a designated entry point (i.e. front door).
2.
Enter your
[
ACCESS
CODE
]
.
3.
If you have access to both partitions (see Partitioning on page 3): Press the key corresponding to the desired partition (
[1]
or
[2]
)
.
For both partitions, press the other key after the confirmation beep.
How do I deactivate an alarm?
Enter your
[
ACCESS
CODE
]
.
ARM
SLEEP
STAY
OFF
No Code
No Code
No Code
To Disarm:
Enter Code
To Sleep Arm:
[
SLEEP
]
+ Code
No Code
To Disarm:
Enter Code
To Stay Arm:
[
STAY
]
+ Code
To Disarm:
Enter Code