Magellan MG5000 User Manual - System Features
Magellan
7
System Features
Programming Chime Zones
A Chime Enabled zone will advise you every time it is opened by causing your keypad to beep.
Each keypad must be Chimed and Muted separately.
To remove the Chime feature from a zone, in step 2 enter the zone number again so the number extinguishes or press
[
SLEEP
]
to remove
Chiming from all zones programmed to Chime. Any zones that are already Chimed will also illuminate. Zones that remain off or
extinguished are not Chimed.
Keypad Muting
When muted, the keypad will only emit the confirmation beep, rejection beep, and beep when a key is pressed. Therefore, when muted,
the keypad will not beep during an alarm and will not beep for chime enabled zones.
Press and hold the
[
CLEAR
]
key for 6 seconds to enable or disable Keypad Muting. If the keypad emits a confirmation beep, Keypad
Muting is enabled for that keypad. If the keypad emits a rejection beep, the feature is disabled.
Keypad Backlight
The illumination level behind the keys can be modified to suit your needs. There are four backlight levels. The
[
S
]
key is used to set the
desired level. Each consecutive push of the
[
S
]
key will increase the backlight level until the maximum level is reached. After reaching
the maximum level, the backlight level will return to the lowest level and the whole process is repeated.
PGM Keys (Programmable Outputs)
Your Magellan system may include one or more programmable outputs (PGMs). When a specific event or condition occurs in the system,
the PGM can be used to reset smoke detectors, activate light switches in your home or office, open/close garage doors and much more.
A PGM can also be programmed to activate whenever the
[ ]
key is pressed and held for 3 seconds, or, if programmed by your
installer, you can press and hold keys
[1]
&
[2]
,
[2]
&
[3]
,
[4]
&
[5]
,
[5]
&
[6]
,
[7]
& [
8]
, or
[8]
&
[9]
for each respective PGM. Press and
hold
[
CLEAR
]
+
[
ENTER
]
for three seconds to perform a smoke reset. These features must be set by your installer.
How do I chime zones?
1. Press & hold the
[
T
]
key for 3 seconds.
2. Select the numbers corresponding to the zones you want to Chime by entering the two-digit zone number. For example, to
chime zone 2 enter
[0]
then
[2]
. The keypad will automatically save once the 2-digit zone number is entered.
3. Press the
[
ENTER
]
key to exit.
How do I modify the backlight?
1. Press and hold the
[
S
]
key for 3 seconds.
2. The
[
MEM
]
key will illuminate.
3. Press the
[
S
]
key to set the desired backlight level.
4. Press
[
CLEAR
]
or
[
ENTER
]
to exit