Magicar M871A User Manual - 4.9.
11
EN
4.9.
PANIC
m
Button IV ––-
ode
Panic mode activation:
Keep
button
IV pressed for 4 seconds.
The door will lock, lights will flash and the siren will be hooting
for 1 minute 30sec.
„PANIC“ symbol will be flashing on display for 30 seconds.
By a short press of button
I you will turn PANIC mode off.
4.10.
Mute siren when armed/disarmed
Buttons (I + II)
Siren on/off when armed/disarmed.
•
Press buttons
I and II shortly.
•
Siren will be off when arming/disarming.
•
You will turn siren back on by pressing buttons
I and II shortly.
If there is no icon
on display of the remote control, acoustic signal
when arming/disarming is off. In this mode siren will not produce any
sound when arming/disarming.
4.11.
Valet mode
Buttons (I + III)
In this mode most of the alarm functions are disabled.
•
Press buttons
I and III shortly.
•
Remote beeps 1x and an icon of the function will appear on
display.
•
Remote will display an icon of the valet mode.
•
You will turn valet mode off by pressing of buttons
I and III shortly.
You can turn the valet mode on by turning ignition on/off 3 times within 3 sec., or by using 2 –
digit PIN code. (see page 15).
Attention!
When the system is in the Valet mode, the alarm is not active, even when the doors are locked. Any
starter or ignition kill systems, that have been installed, will be disabled as well.
Valet mode display:
Button I (0,5s) – lock/unlock
Buttons I+III (0,5s) – valet mode
Button IV (0,5s) – car status control (only armed/disarmed)
Button III (2x short press) – backup light for 10 seconds
Buttons II + III (2sec) – Programming remote menu
If any other functions are attempted, the remote will beep three times and “SLEEP” symbol
will scroll across the screen to indicate that the system is in Valet mode.
If you lend your vehicle to someone who is not familiar with this system, you may want to use
Valet mode to avoid any problems caused by accidental activation of various alarm features
.