Magicar M871A User Manual - 4. Control
7
EN
4. Control
Every command from the remote control accepted by alarm is confirmed by the remote. If not,
you are out of range. In the following text -
•
Short press = 0,5 seconds.
•
Long press = 2 sec ( or 4 sec)
By pressing any button, on the remote control display there will appear an antenna symbol ,
which means signal has been transmitted. If the signal has been accepted and processed,
there will appear a sign
, which means confirming the performance of a command. In a
bottom left corner of display there is an indicator of remote battery life level. As the battery life
is running down, the range of remote control is shrinking at the same time.
4.1.
Arming/disarm
Button I
ing
Arming/disarming, locking/unlocking, turning blocking of the
engine on/off, RPS, turning the siren off.
Arming
(alarm is off, the car is unlocked)
•
Press button
I shortly.
•
Remote will beep 1x and an icon will appear on display.
•
Siren beeps 1x and lights will flash 1x .
•
Alarm will be armed and the car will be locked.
•
LED on RPS sensor will begin to flash.
•
Shock sensor will be activated after 15 sec. While armed, the engine blocking system
against starting attempt is activated. At the same time, if this is on, RPS will be
activated as well.
Attention !
If your hazard lights are on and you will arm the car, it may cause false alarm.
Note:
If, when activating alarm, there are some doors opened, siren will beep 3x, lights will flash 3x, remote
beeps 3x and the door symbol on display will be flashing. Alarm will not turn on! If, when turning alarm
on, some doors are opened, alarm will not turn on, but if you have activated function of door line delay,
alarm will go on no matter if the doors are open or closed.
If the car is equipped with original electronic windows, which require only extension of a locking
impulse to be closed ( VW group), you can require activation of 15s locking impulse in service centre. If
you put a command for turning alarm off during the 15 s locking impulse, the 15 s locking impulse will
be cut of and alarm will go off.
When leaving your parking lights on after stepping out of the car, you will be made aware of it by
beeping of the remote.
Disarming
(alarm is on, the car is locked)
•
Press button
I shortly.
•
Siren will beep 2x and the lights will flash 2x.
•
Remote will beep 2x and an icon will appear on display.
•
Alarm will be on and the car will be unlocked. Start b
will be off as well as RPS.
locking
You can turn acoustic signal off when arming/disarming, if you wish to (page 1)
Alarm memory: