Magicar M871A User Manual - Button II - 2X
8
EN
If in the arming mode the alarm has gone off because of:
•
Opened doors, hood, trunk, additional sensor, 2
nd
- shock sensor zone
Then when turning the alarm off,
the lights will flash 4x and siren with the remote will
beep 4x.
RPS memory:
If in the arming mode RPS sensor has been triggered, the „CALL“ symbol appears on display
at first and then a number of times the sensor was triggered.
Shock sensor memory:
If in the arming mode shock sensor has been activated, first the „Shock“ symbol appears on
display and after that a number of times it was triggered.
Auto rearming:
If you don’t open the door or turn the ignition on within 30 sec. after disarming, the alarm will
arm automatically.
Turning the siren off when alarm has been triggered:
If the alarm has been triggered and siren is hooting, press button
I. The siren will stop, but the
alarm will still be armed. One more press of button
I will disarm the alarm. The system will not
respond for the first few seconds after the alarm was triggered, this is because it is still trying
to send signal out to the remote during that time.
4.2. Vibrating mode On/O
Button II - 2x
ff
ff
By two short presses of button
II the vibrating mode will be activated.
This will be indicated by an icon. Acoustic signal will not be active,
only vibrations, when buttons pressed on remote
.
By pressing the
button
II 2 times again, vibrating mode will be deactivated and the
icon will disappear. Acoustic signal will be activated again.
4.3. AUX Mode Entry On/O
Buttons (III + IV) -–
By outputs AUX 1 and AUX 2 (when AUX2 is set as an additional output - see Programming
menu 2-10) you can operate any additional equipment in your car such as: opening/closing