Main Resource Impact 8024S User Manual - page 12
Courtesy of Main Resource, Inc. Visit us at
www.MainResource.com
or call 800 362-6740 for all your
telecom needs.
Page 12 of 16
Auxiliary Jack on Model 80245 -
This jack allows for a headset, tape recorder, external pager or ringer to be connected to your
phone. One of your programmable buttons must be programmed to enable or disable each
auxiliary device that may be connected to your phone. Only one device may be enabled at a time
and the active device name will be displayed in your LCD.
Headset mode allows you to use the headset instead of the handset or speakerphone. Lifting the
handset will disable the headset for that call. Recorder mode records your call. External ringer
mode uses an external speaker to sound your ring tone. Pager mode sends all voice
announcements sent to your phone to the external paging device. All modes except headset mode
require an external power source.
Program the Enable/Disable Buttons:
1. Press INTERCOM and dial “**1”
2. Press the programmable button
3. Dial a feature code (Headset – 94, External Ringer – 95, Tape Recorder – 96, External Pager
– 97). Press TRNS/CNF
4. Repeat to program all four buttons if needed
5. Press SPEAKER to end.
To use an Auxiliary Mode –
Press the programmed button to enable. The display shows the feature enabled. Press the
corresponding programmed button again to disable.
Message Waiting Light
If your telephone is enabled as a central message desk or has message wait capability, you can
use this feature to illuminate the message waiting light of any phone on the system, alerting the
user that you have a message for them. When they respond, you will be connected to their station
and may relay the message verbally. This may be accomplished whether the station is idle, busy
or not answered.
Turn on Message Waiting Light at a Busy Station –
Remain on the line, press NEXT and MSG then hang up.
Turn on Message Waiting Light at a No-Answer Station –
Press MSG and hang up.
Turn on Message Waiting Light at an Idle Station –
Press INTERCOM, dial “*3” and the extension number of the station to be alerted.
Turn OFF the Message Waiting Light at a Busy or Idle Station –
Press INTERCOM, dial “#3” and the extension number of the station that was alerted.
Turn OFF the Message Waiting Light During Message-Delivering Conversation –
Press INTERCOM.