Majestic 360DVS2 Installation instructions & homeowner's manual - page 37
37
Vermont Castings, Majestic Products, 360DVS Series
10002547
Optional Accessories Available
Fan Kits
Maintenance
The fan itself does not require regular maintenance;
however, periodic cleaning of the fan and the
surrounding area is required.
Check the area under the control door (lower louvre
assembly), and in front of the fan. Wipe or vacuum this
area at least once a month during the operating
season.
Installation
The fan assembly is supplied fully wired eliminating the
need for a licensed electrician to carry out the
installation.
1. Open the lower Louvre assembly. Maneuver the fan
and bracket assembly around the gas valve and
lines to locate the unit against the back wall of the
appliance, resting on the base.
2. With the protective cover removed from the self-
adhesive ‘Velcro’ strips apply mild pressure to the
fan & bracket unit to secure the strips to the metal
panels. No further securing is required.
3. Power to the fan can be supplied by plugging the
supplied lead into a conveniently-located wall
socket by using a hard-wired EB-I receptacle box.
Wiring Instructions
The fireplace, when installed, must be
electrically connected and grounded in
accordance with local codes, or in the
absence of local codes, with the current
CSA C22.1 Canadian Electric Code. For
USA installations, follow local codes and
the National Electrical Code
ANSI/ NFPA No. 70.
Any electrical rewiring of this fan must
be done by a licensed electrician.
Should this fan require servicing or
repair, the power supply must be
disconnected. For rewiring of any
replacement parts, see Fig. 51.
FK24 Fan Assembly
This auxiliary fan system increases the efficiency of the
circulation of the heated air.
The FK24 fan kit allows variable speed control of the
circulation fan and also incorporates a heat sensor in
the circuit.
Specifications
115 Volt / 60Hz / 56 Watts
Maintenance
The fan itself does not require regular maintenance,
however periodic cleaning of the fan and the
surrounding area is required.
Check the area under the control door (lower louvre
assembly) and in front of the fan and wipe or vacuum this
area at least once a month during the operating season.
Installation
The fan assembly and other components are supplied
fully wired, eliminating the need for a licensed
electrician to carry out the installation.
If hard wiring the fan in using Method B (following) we
strongly recommend the use of a licensed electrician.
1. Open the lower louvre assembly. Maneuver the fan
and bracket assembly around the gas valve and
lines to locate the unit onto the screw studs on the
back of the fireplace.
2. Install the thermal sensor under the bottom of the
firebox, locating it over the two (2) 10 mm studs,
and secure it with nuts.
3. Locate the fan speed control unit. This can be fitted
behind the lower louvre assembly as in Fig. 50, or
located remotely in a conveniently located wall
mounted electrical box. Remote location of the
speed control will require suitable extension of the
component wiring.
4. The power supply may be connected in two ways:
Method A
Route the 6’ lead fitted to the unit to a conveniently
located wall socket.
Method B
The EB-I receptacle box (Pt. # ZA1200) may be
hard-wired into the house supply. The fan lead is
then plugged into the EB-I box.
FK12
This auxiliary fan system increases the efficiency of the
circulation of the heating air.
The FK12 Fan Assembly is a fixed speed fan system
and does not allow for variable speed control. It does
not use the speed control unit or the heat sensor
included with the FK24 Kit.
Specifications
115 Volts / 60 Hz / 56 Watts.
Fan Kit/EBI
FK24 Fan
Heat Sensor
Electrical Inlet
Hole
Gas Inlet Hole
Electrical Box (EB-1)
Fan Speed
Control Box
Fig. 50 Fan