Major's Mobisist Prestige User Manual - page 13
WU’S Tech Electric Scooter Range - User Manual (Page 13 of 24)
5 . B AT T E R Y C H A R G I N G A N D C A R E
5.1 CHARGING THE BATTERY –WT-M3/M4/L3/L4
Follow the procedure below step by step:
1. Turn the power switch to (OFF)
2. Connect the charger’s power cord into the power outlet.
3. Open the charging socket cap on the scooter’s tiller. Then connect the
charger’s round plug to the charging socket.
4. Turn on the switch on the charger.
5. Both the charger’s red and orange LEDs will be lit when beginning
charging. The charging duration is about 6 hours. To ensure optimum
performance a 10-hour charge is recommended. But we do not
recommend a charging more than 24 consecutive hours.
6. Both the charger’s LEDs will be lit during the charging process. The
orange LED will turn green when charging is complete.
7. Turn off the charger; disconnect the power cord and the round plug from charger socket on the scooter.
Warning
♦
The fan inside the charger will be activated accordingly when you turn on the charger. If the fan does
not work when connected to the charger or the green light is not showing, DO NOT use this charger.
It may lead to overheating of the charger and cause a fire as a result.
♦
There is a red LED present on the charger to illustrate operation. If this LED does not illuminate the
charger is defective, please contact your dealer.
Attention
♦
While gripping or folding the handle bar, beware of finger or hands caught in the handle area.
♦
While returning the battery pack to the battery pack cavity of shroud, beware of finger or hands.
♦
A flap on the end of battery pack can be opened to place your bag not over 3 kgs.
■
Charging Hours
The charging duration is about 8 hours. To ensure optimum performance a 10-hour charge is
recommended. But we do not recommend a charging more than 24 consecutive hours.
■
Charging status LED
You can charge your battery on or off of the scooter, but be sure to turn the power switch off before
connecting the charger’s power cord into the power cord receptacle. The LED will be lit to orange
when beginning charging. The orange LED will turn green when charging is complete.