Major's Mobisist Prestige User Manual - page 16
WU’S Tech Electric Scooter Range - User Manual (Page 16 of 24)
5 . B AT T E R Y C H A R G I N G A N D C A R E
■
Batteries replacement
1. Place the battery pack belly up, then remove the fourteen (14) screws on the battery pack base.
2. Open the battery pack base up.
3. Disconnect the negative terminal (black) wires first, then positive (red) wires next by removing the
four nuts and bolts from each battery terminals.
4. Remove the batteries.
5. Place new battery.
6. Connect the positive terminal (red) wires first, then negative (black) wires next by tighten the nuts
and bolts on each battery terminals.
7. Close the battery pack base, and then tighten the fourteen screws.
■
Charger replacement
1. Follow procedure 1 and 2 above.
2. Turn the battery up as photo showed in right.
3. Remember how the wire and socket are situated in the battery pack before you move the charger’s
wire and socket.
4. Unplug the socket to remove the charger, then replace a new one.
5. Situate the wire, socket and LED well onto the battery pack as it is originally.
6. Following procedure 7 above.
Warning
1.
The wiring system and charger are well situated in battery pack while assembled in plant. Do not
attempt to re-locate the wiring system by yourself. The improper layout of wiring system may
result in the wires pinched by battery box, which might the electronic system failure.
2.
Be sure the battery wires are connected to their right battery terminal.
Suggestions
If necessary, ask for help from your dealer for advice about maintaining and replacing the battery.
Suggestions
1.
Make sure the terminals are installed properly and put the cover back on.
2.
Do not use the battery to charge telecom equipment or other items.
3.
Battery efficiency will vary with outside conditions; the driving distances will be shorter in the
winter. If the vehicle is not used for a long time, please charge the battery at least every week.
4.
Replace both batteries together.