Major's Mobisist Prestige User Manual - page 19
WU’S Tech Electric Scooter Range - User Manual (Page 19 of 24)
7 . D I S A S S E M B LY A N D A S S E M B LY
7.1 DISASSEMBLING THE SCOOTER –
WT-M3/M4/L3/L4
The procedures for assembling and disassembling are very similar for the WT-M3/M4/L3/L4 scooters.
The following procedure is to disassemble the scooter for transportation:
1. Switch off the scooter at the key ignition.
2. Unscrew the seat hand wheels and remove seat. Be careful with the seat as it is heavy.
3. Lift up the rear shroud (1) and
disconnect the rear light loom at the
connector (2) and remove the rear
shroud completely (as shown in the
photographs below).
4. Next, Disconnect the batteries by
disconnecting the red connector from
the red connector (3) and black
connector from the black connector
(4). Then, undo the hook-and-loop
strap (5) and remove the batteries (6).
Please see the photographs below.
5. Disconnect the main loom to
separate the wiring between the
front and rear of the scooter (not
shown).
a. WT-M3/M4: For
M3
only it is
necessary to slacken off the two
frame tensioning bolts in order that
the locking pin may be removed (8).
Pull up and remove the locking pin
(9) and remove the two nuts and
bolts, which hold the separate
chassis frames together (10). Finally
pull the chassis of the scooter apart
to separate. (11)
(WT-M3 and M4
only)
b. WT-L4: Pull up and remove the 3
locking pin (12). The brake cable
can be separated by removing the
clip and locking pin (13). Finally
pull the chassis of the scooter apart
to separate.