Major's Mobisist Prestige User Manual - page 15
WU’S Tech Electric Scooter Range - User Manual (Page 15 of 24)
■
Cleaning the battery
If the batteries are contaminated by water, battery acid, dust or other substances, they will discharge
quickly. The batteries supplied with the scooter are sealed and as such are maintenance free with no risk
of battery leakage. Please follow the steps below to clean the battery.
1. Turn the scooter power switch to “OFF”.
2. Remove the seat and dust cover.
3. Remove the shroud and unplug the terminal of the taillight and signal lights.
4. Use a clean cloth to wipe off the soiled area.
5. Take out the battery.
6. Clean the battery with a clean cloth. If the terminal is covered by white powder, please wipe it clean
using warm water.
Warning
1. The wiring system and charger are well situated in battery pack while assembled in plant. Do not
attempt to re-locate the wiring system by yourself. The improper layout of wiring system may result
in the wires pinched by battery box, which might the electronic system failure.
2. Be sure the battery wires are connected to their right battery terminal.
Suggestions
If necessary, ask for help from your dealer for advice about maintaining and replacing the battery.
Suggestions
1. Make sure the terminals are installed properly and put the cover back on.
2. Do not use the battery to charge telecom equipment or other items.
3. Battery efficiency will vary with outside conditions; the driving distances will be shorter in the
winter. If the vehicle is not used for a long time, please charge the battery at least every week.
4. Replace both batteries together.
5 . B AT T E R Y C H A R G I N G A N D C A R E