Major's Mobisist Prestige User Manual - page 20
WU’S Tech Electric Scooter Range - User Manual (Page 20 of 24)
7 . D I S A S S E M B LY A N D A S S E M B LY
7.2 ASSEMBLING THE SCOOTER (
Prestige
)
1. Push the two halves of the scooter together and reinsert the locking pin, also tightening tension bolts
on
WT-M4
. Reconnect the main loom.
(M3 and M4 only)
2. Reinstall the batteries and secure them with the hook-and-loop strap.
3. Reconnect the batteries ensuring the two red connectors are together, and the two black connectors are
together. DO NOT CONNECT A RED CONNECTOR TO A BLACK CONNECTOR.
(
WT-M3/M4/L3/L4)
4. Reconnect the rear light loom and replace the rear shroud and rubber shroud cover.
5. Replace the seat and secure with the knob.
■
TROUBLE SHOOTING
Symptom
Remedy
The scooter will not switch on
•
Try recharging the battery
•
Check the fuse and circuit breaker in the scooter
The scooter switches on, but the
scooter will not move.
•
Ensure there is enough power in the batteries. If not, recharge
the batteries.
•
Ensure the freewheel lever is engaged in the ‘DRIVE’
position.
The scooter appears slow
•
Check the battery power level and recharge
•
Check the speed dial is not set to slow.
The seat turns when in operation
•
Slowly rotate the seat until it drops in to place and is secure
The handlebar appears loose
•
Tighten the height adjustment handle to secure the handlebar
Involuntarily horn sounds
•
Ensure that the wigwag paddle is released.
•
Switch the scooter off and on.
•
Recharge the batteries.
•
If problem persists contact your dealer.