Makita 6402 Instruction Manual - Specifications
2
ENGLISH
SPECIFICATIONS
Model 6402
DP4700
Steel
10 mm
13 mm
Capacities
Wood
21 mm
36 mm
No load speed (min
-1
)
0 - 1,200
0 - 550
Overall length
264 mm
275 mm
Net weight
1.7 kg
2.0 kg
Safety class
/II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
END201-2
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
・ Read instruction manual.
・ DOUBLE
INSULATION
・ Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible
recycling facility.
ENE032-1
Intended use
The tool is intended for drilling in wood, metal and
plastic.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model DP4700
ENG102-1
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745-2-1:
Sound pressure level (L
pA
) : 86 dB(A)
Sound power level (L
WA
) : 97 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG202-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745-2-1:
Work mode: Drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
ENH101-8
EC-DECLARATION OF CONFORMITY
Model; DP4700
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 2004/108/EC, 98/37/EC.
CE2007
000230
Tomoyasu Kato
Director
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
GEA001-3
GENERAL SAFETY RULES
WARNING! Read all instructions. Failure to follow all
instructions listed below may result in electric shock, fire
and/or serious injury. The term "power tool" in all of the
warnings listed below refers to your mains-operated
(corded) power tool or battery-operated (cordless) power
tool.
SAVE THESE INSTRUCTIONS.
Work area safety