Makita JS1600 Instruction Manual - Operation
5
1
2
3
4
004680
NOTE:
•
No thin washers are used for the lower blade.
Install the upper blade and tighten the upper blade
securing bolt with the hex wrench. Press up on the upper
blade while tightening it.
1
2
3
004681
After securing the upper blade, be sure that there is no
gap left between the upper blade and the beveled
surface of the blade holder.
1
2
3
4
004683
When installing the lower blade onto the yoke, the lower
blade should be pressed against the yoke so as to be
contacting the beveled portions A and B of the yoke and
the tip C of the lower blade positioning screw while you
tighten the lower blade securing bolt. There must be no
clearance between A, B and C during installation.
1
2
3
004686
1
2
3
A
B
C
004687
NOTE:
•
The lower blade positioning screw is
factory-assembled. Do not tamper with it.
OPERATION
Holding material
1
004699
The materials for cutting should be fastened to the
workbench by means of workholders.
Shearing method
004701
Keep the shear moving parallel with the material.
Maximum cutting width
1800 mm
(70-7/8")
A
1
004703
Stay within the specified maximum cutting width (A):
Case of length 1,800 mm (70-7/8").
1. Cutting line
1. Workholder
1. Yoke
2. Lower blade
positioning
screw
3. Lower blade
1. Lower blade
2. Tighten
3. Yoke
1. Blade holder
2. Upper blade
securing bolt
3. Upper blade
4. No gap allowed
1. Tighten
2. Upper blade
securing bolt
3. Upper blade
1. Thin washers
2. Blade holder
3. Upper blade
4. Upper blade
securing bolt