Meec Tools 000-138 Operating Instructions Manual - Service
EN
49
• Keep the power tool properly maintained. Check that moving parts are not misaligned,
jammed or loose, and that there are no other factors that could affect the safe use of
the tool. If the power tool is damaged, it must be repaired before being used again.
Many accidents are caused by poorly maintained power tools.
• Make sure that cutting tools are sharp and clean. Properly maintained cutting
tools with sharp cutting edges are less likely to jam and are easier to control.
• Use the power tool, accessories and bits etc., in accordance with these
instructions, taking into account the actual working conditions and the work
that is to be done. Using the power tool for anything other than its intended
purpose can lead to dangerous situations.
Service
• Make sure that the power tool is serviced by qualified technicians that only use
identical spare parts. This will ensure that the power tool remains safe to use.
Safety instructions for drilling
• Use ear protection for percussion drilling. Exposure to loud noise can cause
hearing impairment.
• Use the support handles, where appropriate. Losing control of the power tool
can result in personal injury.
• Hold the power tool by the insulated grips when working in areas where the
drill can come into contact with concealed electrical cables or its own power
cord. When cutting accessories come into contact with a live wire, unprotected
metal parts on the tool can become live and give the user an electric shock.
Vibration and noise attenuation
• To reduce the effects of noise and vibrations, you should limit the time in use, use
the low-vibration and low-noise modes and wear personal protective equipment.
• Observe the following to minimise the risk of exposure to vibrations and loud noise:
– Only use the power tool for the purpose it was designed for and accord-
ing to these instructions.
– Make sure that the product is in good condition and well maintained.
– Use the right accessories for the product and make sure they are in
good condition.
– Keep a firm hold on the handle/grip.
– Maintain the product according to these instructions and ensure that it is
well lubricated (where applicable).