Meec Tools 000-138 Operating Instructions Manual - Maintenance
EN
59
MAINTENANCE
NOTE: Always switch off the product, unplug it from the power source and allow it to cool before
inspecting, maintaining or cleaning it.
IMPORTANT: Only carry out repairs and maintenance according to these instructions. All other work
must be carried out by a qualified technician.
Cleaning
1.
Keep the product clean. Always remove waste from it after use and before putting it away.
2.
Clean the product with a dry cloth. Use a brush on areas that are hard to reach.
3.
Pay special attention to cleaning the air vents with a cloth and brush after use.
4.
Remove stubborn dirt with compressed air (max 3 bar).
NOTE: To avoid surface damage, do not use chemical, alkaline, abrasive or other strong detergents or
disinfectants to clean the product.
Inspection
• Check that the product and its accessories are not worn or damaged before and after use.
• Check that there are no worn or damaged parts.
• Replace worn parts, or have the product repaired by an authorised service centre before using it
again. Observe the technical requirements.
Power cord
If the power cord on this power tool is damaged it must be replaced by an authorised service centre.
Repairs
This product does not contain any parts that can be repaired by the user. Have an authorised service
centre or qualified technician examine and repair the product.
Storage
1.
Switch off the product and unplug it from the power source.
2.
Clean the product as described above.
3.
Store the product and its accessories in a dark, dry, frost-free and well ventilated area.
4.
Always store the product out of the reach of children. The ideal storage temperature is
between 10 and 30°C.
5.
We recommend using the original packaging for storage, or covering the product with a
suitable cloth or the equivalent to protect it from dust.