Meec Tools 000-138 Operating Instructions Manual - Troubleshooting
EN
60
Transport
1.
Switch off the product and unplug it from the power source.
2.
Always carry the product by holding the main handle.
3.
Protect the product from heavy knocks and strong vibrations when transported in a vehicle.
4.
Secure the product to prevent it slipping or falling down.
TROUBLESHOOTING
Problem
Possible cause
Action
The product will not start.
It is not connected to a power
source.
Connect to power source.
The power cord, or plug, is
defective.
Have the product checked by an
authorised electrician.
Other electrical fault on the
product.
Have the product checked by an
authorised electrician.
The product does not reach full power. The extension cord is not suitable
for use with this product.
Use a suitable extension cord.
The power source (e.g. generator)
has low voltage.
Connect to another power source.
The air vents are blocked.
Clean the air vents.
Unsatisfactory results.
The drill is blunt/damaged.
Replace with a new one.
The drill is not suitable for the
workpiece material.
Use a suitable drill.
Heavy vibrations or abnormal noise. The drill is blunt/damaged.
Replace with a new one.
Screws/nuts are loose.
Tighten screws/nuts.