Meec Tools 000-138 Operating Instructions Manual - Assembly
EN
54
ASSEMBLY
Unpacking
1.
Unpack all the parts and place them on a level and stable surface.
2.
If necessary, remove all packaging material and transportation devices.
3.
Check that the delivery is complete and undamaged. Do not use the product if any parts are
missing or damaged, contact your dealer instead. Using an incomplete or damaged product
is dangerous and can result in personal injury or material damage.
4.
Make sure that you have all the accessories and tools required for assembly and use. This also
includes suitable personal safety equipment.
WARNING: The product and packaging are not toys. Do not allow children to play with plastic bags,
sheets and small parts. There is a risk of suffocation.
IMPORTANT: The product must be fully assembled before it is used. Do not use a product that is only
partially assembled or assembled with damaged parts. Do not connect the product to a power source
before it is fully assembled.
Fitting the support handle
Adjust the support handle for the required application.
This improves your control when using the product.
1.
Turn the handle clockwise to release the clip.
2.
Put the quick-release clip on the collar (4).
3.
Adjust the support handle to the required
position so that you can hold the product
safely when in use. Make sure the slot in the
support handle is engaged with the tooth in
the collar.
4.
Turn the handle anticlockwise to tighten
the clip.
WARNING: To prevent accidents and personal injury, do not use the product without the support
handle. Make sure the support handle is properly attached before use. The support handle helps you
to better control the force produced if the product suddenly stops when in use.