Meen Green MGP-20 Owner's Manual - page 20
Service
Park the mower on level ground. Rotate key
to OFF position and remove key from switch before doing any
maintenance. Disconnect battery cables by pulling up out on the
LARGE RED
battery quick
disconnect handle! Wait for all movement to stop before
adjusting, cleaning or repairing. Repairs or maintenance
requiring power should be performed by trained maintenance
personnel only. Read and observe safety warnings
in front of manual.
• Any maintenance operation that requires
the removal of safety covers must be performed
by a trained service technician.
Before working on or under the deck, make certain master power ignition
switch is OFF and key is removed and deck blade switch cannot be accidentally
started. Disconnect battery cables by pulling up out on the
LARGE RED
battery quick
disconnect handle for maximum safety!
Repairs or maintenance requiring power should be performed by
trained maintenance personnel only.
Use a stick or similar instrument to clean under the
mower making sure that no part of the body, especially
arms and hands are under mower.
Keep your machine clean and remove any deposits of trash and clippings, which
can cause fires and overheating. Allow machine to cool before storing.
*Clean flammable material from machine. Prevent fires by keeping battery
compartment, deck and operator’s station clean of accumulated trash, grass clippings,
and other debris.*
Clean battery compartment, mower deck, etc. of all dirt and debris. DO NOT spray
unit with water. Do not use, solvents, hard cleaners or
abrasives. Use only compressed air.
Always wear adequate eye protection when servicing the
batteries, or when grinding mower blades and removing
accumulated debris.
Never attempt to make any adjustments or repairs to the mower deck or any attachment
while the blades are engaged. Repairs or maintenance requiring power
should be performed by trained maintenance personnel only.
Never work under the machine or attachment unless it is
safely supported with jack stands. Make certain machine
is secure when it is raised and placed on the jack stands.
The jack stands should not allow the machine to move
when the traction drive system is running and the drive
wheels are rotating. Use only certified jack stands. Use
only appropriate jack stands, with a minimum weight rating
of 2000 pounds (907.2 kg) to block the unit up. Use
in pairs only. Follow the instructions supplied with the
vehicle stands.
Do not touch hot parts of machine.
Keep nuts and bolts tight, especially the blade attachment
bolts. Keep equipment in good working condition.
Never tamper with safety devices. Check their proper
operation regularly.
Turn the key to the OFF position before unclogging the discharge chute.
Never clear the discharge chute with the machine running. Turn
the key to the OFF position and be sure the blades have
stopped. Disconnect battery cables by pulling out on
LARGE RED
battery quick disconnect handle for maximum
safety before cleaning. Use a stick to clear a plugged
discharge area. Never use your hand!
Stop unit, and allow blades to stop before unclogging chute.
Grass collection system components are subject to wear,
14